2/16/2024 9:00:00 AM
Summary: 36V, 5A configurable frequency device with built-in high/low-side power mosfet.
The Monolithic Power System (MPS) MPQ4341/4341J synchronous buck converters are 36V, 5A configurable frequency (350kHz to 2.5MHz) devices with integrated high-side and low-side power mosfets (HS-FET and LS-FET respectively) . The converters deliver up to 5A of high-efficiency output current (IOUT) with fixed-frequency zero-delay PWM (ZDP) control for near-optimal transient response. 3.3V to 36V wide input voltage range, 42V load dump support, adaptable to various buck applications in automotive input environments. The MPQ4341/4341J converters feature 1µA shutdown current (ISD), allowing the device to be used in battery-powered applications.
High power conversion efficiency over a wide load range can be achieved by reducing the switching frequency (fSW) under light load conditions to reduce switching and gate driver losses. The PG (open-drain power good) signal indicates whether the output voltage (VOUT) is between 94% ~ 106% of the nominal voltage range. Thermal shutdown provides reliable fault-tolerant operation. High duty cycle and low dropout (LDO) modes provide automotive cold crank conditions.
The MPQ4341 is available in a QFN-17 (3mm x 4mm) package, and the MPQ4341J is available in a QFN-19 (3mm x 4mm) package. Both versions are AEC-Q100 certified.
Designed specifically for automotive applications
Withstands 42V load dump
Supports up to 3.1V cold crank
LDO (Low-dropout) mode
Up to 5A continuous output current
Can work continuously up to 36V
Zero delay PWM control
multi-stage capabilities
At least 20 seconds on time
Junction temperature operating range -40℃~ +150℃
AEC-Q100 Level 1
Extend battery life
1μA low shutdown current
3μA sleep mode quiescent current
Advanced Asynchronous Modulation (AAM) mode improves efficiency at light loads
Improved thermal performance with internal 60 milliohm high-side MOSFET and 35 milliohm low-side MOSFET (HS-FET and LS-FET respectively)
Optimized for EMC/EMI
Configurable switching frequency from 350kHz to 2.5MHz
Symmetrical V(IN) pin
Frequency spread spectrum (FSS) modulation
CISPR25 Level 5 Standard
MeshConnect flip chip packaging
1V, 1.1V, 1.8V, 2.5V, 3V, 3.3V, 3.8V, 5V fixed output options
Can be synchronized with external clock
Synchronized clock output
Power Good (PG) output
External soft start
Hiccup Overcurrent Protection (OCP)
Available in packaging, all with wettable flanks
QFN-17 (3mm x 4mm) package for MPQ4340
QFN-19 (3mm × 4mm) package for MPQ4340J
car cluster
Automotive Infotainment
Advanced driver assistance system (ADAS)
Industrial power systems
Phone