2/8/2024 9:10:34 AM
Summary: Ability to evaluate, design, implement and validate FS23x fail-safe, body/comfort SBCs.
The NXP Semiconductors FS23 SBC PMIC evaluation board enables the evaluation, design, implementation and verification of the FS23x fail-safe, body/comfort system base chip (SBC). The KITFS23LDOEVM and KITFS23SKTEVM boards are solder-down boards that support the FS2300 fail-safe SBC. The KITFS23LDOEVM provides three low dropout (LDO) regulators, while the KITFS23SKTEVM board provides three LDOs and an FS2320 fail-safe SBC with an SMPS and two LDOs. The KITFS23BUKEVM board is a soldered board supporting the FS2320 fail-safe SBC with one SMPS and two LDO regulators. Devices can be easily placed and removed from the circuit board using sockets. KITFS23LDOEVM and KITFS23BUKEVM include a soldered FS2320 device with empty OTP content, allowing the user to burn OTP configuration.
3.81mm male connector or jack connector for power input
3.81mm male connector for hvldo
3.81mm male connector for HVBUCK (KITFS23BUKEVM and KITFS23SKTEVM)
3.81mm male connector for CAN and LIN communications
3.81mm male connector for high-side drivers
Selectable debug mode, test mode, and normal mode switches and jumpers to power the device in different modes
INTB, RSTB, FS0B, LIMP0, FCCU pins
Header connector for I/O configuration
Embedded USB to I(2)C/SPI protocol to facilitate connection to software GUI via S32K144 microcontroller
Red and green LEDs indicate signal or regulator status
Blue LED indicates setting OTP 8V combustion voltage
Advanced system monitoring via S32K144 microcontroller
Require
Computer using USB interface, install Windows 7 or Windows 10
FTDI USB serial port driver (applicable to FT230x basic UART device)
1x power supply with range up to 40V
system
body control module
HVAC
illumination
Steering column lock
Seat module
roof module
door control module
car access
gear shift
seat belt pretension
back door
alarm
KITFS23LDOEVM
Assemble and test evaluation board in anti-static bag with pre-programmed S32K144 microcontroller
3.0ft USB-STD A to USB-B Micro Cable
6 connectors, terminal block plug, 2 positions, straight, 3.81mm
3x connector, terminal block plug, 3x position, straight, 3.81mm
Jumpers installed on board
KITFS23BUKEVM
Assemble and test evaluation board in anti-static bag with pre-programmed S32K144 microcontroller
3.0ft USB-STD A to USB-B Micro Cable
6 connectors, terminal block plug, 2 positions, straight, 3.81mm
6 Connectors, Terminal Block Plug, 3 Positions, Straight, 3.81mm
Jumpers installed on board
KITFS23SKTEVM
Assemble and test evaluation board in anti-static bag with pre-programmed S32K144 microcontroller
3.0ft USB-STD A to USB-B Micro Cable
4 Connectors, Terminal Block Plug, 2 Positions, Straight, 3.81mm
4 Connectors, Terminal Block Plug, 3 Positions, Straight, 3.81mm
Jumpers installed on board
Phone